Ureka Global Ltd
(formerly Alansons Industries Ltd)
7 Flowers Hill
+44 (0)117 971 1364
The Henko 640A Hook Blades are high performance knife blades used with the Henko 645 Delphin Knife.
The Henko 670 Rotation Brush is a powered piece of equipment used for brushing artificial grass and distributing infill materials.
The Henko 671 Rotation Brush is a powered machine for brushing artificial grass after installation and when maintaining the grass. The Henko 671 Rotation Brush gives the same benefits as the Henko 670 machine but it is self-propelled.
Permabond A025 is an anaerobic adhesive formulated to provide permanent locking and sealing of metal parts such as bearings, gears, studs and other threaded components.
Permabond A131 is an anaerobic adhesive designed to seal threaded metal pipe connections carrying a wide variety of gases and liquids, including potable water.
Permabond A905 Surface Activator is designed to allow non-metallic surfaces to be bonded/sealed. It also accelerates the cure rate of anaerobics and improves bonding to contaminated surfaces. It will also allow the adhesive to cure in a larger gap.
PERMABOND C910 is the original 100%-methyl cyanoacrylate adhesive. It is a single part, low viscosity liquid that will cure rapidly at room temperature when pressed into a thin film between parts.
Permabond C Surface Activator (CSA) is used in conjunction with Permabond cyanoacrylate adhesives to promote a fastercure and to extend their gap-filling capabilities.
PERMABOND ES562 is a single-part epoxy adhesive which flows like solder when heated during curing. The adhesive has excellent adhesion to metal surfaces and composites.
PERMABOND ES566 is a single-part epoxy adhesive which has excellent adhesion to metal surfaces, composites and difficult to bond plastics (such as Nylon, PBT etc.).
PERMABOND ET5441 is a thermally conductive two-component adhesive based on epoxy resin. It is specifically designed to bond metal substrates when excellent resistance to high temperature is required.
PERMABOND ET5429 is a thixotropic two-part adhesive with excellent resistance to impact and vibration. The controlled flow properties enables the adhesive to be used where gap filling or vertical application is required.
Permabond Initiator 41 is used in conjunction with Permabond TA(structural acrylic) adhesives as a no-mix resin and initiator system. Its solvent free formulation allows a long open time if required.
PERMABOND TA437 is a single component structural acrylic adhesive designed primarily for bonding metals, ferrites and ceramics. The typical fixture time of TA437 when used with Initiator 41 is 20-30 seconds
PERMABOND TA4610 is a 2-part, 1:1 toughened acrylic adhesive. It has been developed to bond low surface energy plastics such as polypropylene and polyethylene with no primer or surface treatment required.
PERMABOND UV6302 is a single part, fast setting, and UV curable adhesive designed specifically for bonding plastics. This material has excellent adhesion to a variety of plastics including polycarbonate.
Replacement Alloy Regulating Roller for use with Pfohl Adhesive Rollers
Replacement Plastic Axle for use with Pfohl Adhesive Rollers
Replacement Plastic Handle for use with Pfohl Adhesive Rollers
Special hotmelt applied at lower temperature. Ideal for heat sensitive products and reduced risk of accidental burns.
Tesa® 4613 is a utility grade duct tape. It consists of a 27 mesh woven PET/cotton fabric backing coated with a natural rubber adhesive.
Adtech® P1402 is a single component primer which is used with Adtech® cyanoacrylates and enables the bonding of difficult to bond plastics.
Woodstikk Surface Floor Primer is an acrylic based solvent free sealer and primer coating which is used for bonding absorbent and powdery cementous subfloors prior to bonding wood flooring down.
Alpha Thixofix Eco is an easy to use, water-based high performance contact adhesive based on polychloroprene latex that has been developed especially to make high strength, permanent bonds on a wide variety of materials.