Henko 638 Activator is used with R300 and R305 to speed up the cure. Highly advised when installing synthetic turf in cold weather conditions.
Woodstikk® Mitre Stikk Adhesive kit comprises of a medium viscosity superfast cyanoacrylate adhesive and an aerosol containing activator.
Adtech® Mitre Bond Adhesive kit comprises of a medium viscosity superfast cyanoacrylate adhesive and an aerosol containing activator.
Adtech® 1001 is a solvent-based activator formulated to increase the cure speed of Adtech® cyanoacrylate adhesives.
Adtech® 1002 is a superfast solvent-based activator formulated to increase the cure speed of Adtech® cyanoacrylate adhesives.
Rosehill Flexilon FX1117 is a low viscosity, solvent-free, single component rubber pre-treatment accelerator for use in conjunction with Rosehill Flexilon wet pour polyurethane binders.
Adtech 1008 Activator is a slow curing activator which is used with Adtech 9146, a two component structural methacrylate adhesive.
Adtech 1010 Activator is a fast curing activator which is used with Adtech 9146, a two component structural methacrylate adhesive.
Aro-Seal 1109 is a degreaser and adhesion promoter which is used in conjunction with Aro-Seal MS and Hybrid Polymers to improve adhesion on plastics.
LOCTITE SF 7649 is a solvent-based activator for surface preparation that provides for low temperature curing.
Permabond A905 Surface Activator is designed to allow non-metallic surfaces to be bonded/sealed. It also accelerates the cure rate of anaerobics and improves bonding to contaminated surfaces. It will also allow the adhesive to cure in a larger gap.
Permabond C Surface Activator (CSA) is used in conjunction with Permabond cyanoacrylate adhesives to promote a fastercure and to extend their gap-filling capabilities.
Permabond Initiator 41 is used in conjunction with Permabond TA(structural acrylic) adhesives as a no-mix resin and initiator system. Its solvent free formulation allows a long open time if required.
Page 1 of 1