Adtech® 6505 is designed for the sealing and locking of metal fittings and pipes.
Adtech® 6505 is a single component anaerobic, medium strength thixotropic, acrylic based product.
Adtech® 6505 cures when confined in the absence of air between close fitting metal surfaces and prevents leakage and loosening from vibration and shock.
Ensure that the surfaces to be bonded are smooth, clean and free from dust or other deposits.
The rate of cure is dependent on the substrates being used, the gap fill required and the ambient temperature at the time of the cure. When the cure speed is unacceptably long, or larger gaps are present, using Adtech® 1006 Activator will improve the cure speed. If the material is an inactive metal consider using activator.
Shake the product thoroughly before use. Apply the product to the male fitting on the leading threads in a 360º bead, leave the first thread free, making sure all voids are full. For bigger threads apply more product accordingly and putting a bead on the female. Assemble and tighten as required. Properly tightened fittings will seal to moderate pressures instantly. For maximum resistance allow a minimum of 24 hours to cure.
To prevent the clogging of the nozzle, do not let the tip touch metal surface during application.
For disassembly, use localised heat to bolt or nut, disassemble while hot.
Use proper ventilation; avoid contact with skin and eyes. If contact with skin occurs, rinse with warm water or dissolve gradually with appropriate debonder. Do not try to remove forcibly. If adhesive gets into eye, keep eye open and rinse thoroughly. Seek medical attention immediately. Keep well out of reach of children. To remove cured product use a combination ofsolvent and abrasion such as a wire brush.
Adtech® 6505 should be stored in the original containers in a cool, dry place, at a temperature range of between 5°C and 20°C. In these conditions it has a storage life of at least 12 months
Click the button above to ask a question.
Adtech® 1006 is a solvent-based activator formulated to improve the curing process of Adtech® anaerobic adhesives.
Adtech® 6204 is an anaerobic threadlocker designed for the sealing and locking of threaded fasteners which may require easy disassembly with standard hand tools.
Adtech® 6208 is an anaerobic threadlocker designed for the sealing and locking of threaded fasteners.