Ureka Global Ltd
Unit 5 Decoypool Road
St Modwen Park
NP19 4RG

0117 971 1364

Adtech 6608 High Strength Retainer

Adtech® 6608 is designed for the bonding of cylindrical fitting parts, particularly where bond gap can approach 0.25mm.

Add to Basket
Available for deliverySpend £500.00 to get free delivery.
Bulk discount availableCall 0117 971 1364 for prices.

Need help?

Call us on 0117 971 1364 or click the button below.

Request a call


Adtech® 6608 is a single component anaerobic, acrylic based product. The product cures when confined in the absence of air between close fitting metal surfaces and prevents leakage and loosening from vibration and shock.


  • 10ml bottle
  • 50ml bottle
  • 250ml bottle

Featured Properties

  • Best resistance to dynamic, axial and radial loads
  • Ideal for shafts, gears, pulley and similar cylindrical parts


Ensure that the surfaces to be bonded are smooth, clean and free from dust or other deposits.

The rate of cure is dependent on the substrates being used, the gap fill required and the ambient temperature at the time of the cure. When the cure speed is unacceptably long, or larger gaps are present, using Adtech® 1006 Activator will improve the cure speed. If the material is an inactive metal consider using activator.

Shake the product thoroughly before use. Assemble and tighten.

For shrink fitted assemblies, the adhesive should be coated onto the pin. The collar will then need to be heated to create sufficient clearance for free assembly.

For slip fitted, apply adhesive inside of the collar then to the leading edge of the pin, then use a rotating motion in assembly to ensure coverage.

For press fitted assemblies, apply adhesive thoroughly to both bond surfaces and assemble at high press on rates.

To prevent the clogging of the nozzle, do not let the tip touch metal surface during application.

For disassembly, use localised heat to bolt or nut, disassemble

Handling and Storage

Use proper ventilation; avoid contact with skin and eyes.  If contact with skin occurs, rinse with warm water or dissolve gradually with appropriate debonder.  Do not try to remove forcibly.  If adhesive gets into eye, keep eye open and rinse thoroughly. Seek medical attention immediately.  Keep well out of reach of children.

To remove cured product use a combination of solvent and abrasion such as a wire brush.

Adtech® 6608 should be stored in the original containers in a cool, dry place, at a temperature range of between 5°C and 20°C. In these conditions it has a storage life of at least 12 months.


5 StarsLinda Lainton2 Years Ago


5 StarsPHILIP DYSON2 Years Ago

as described

Average Rating

5 Stars

Questions & AnswersQ&A's

Click the button above to ask a question.



Adtech® 6608 High Strength Retainer Technical Data sheet




Adtech® 6608 High Strength Retainer Safety Data sheet



Let’s get stuck in.

Got an adhesives problem? Let our sticky smarts work for you.

Call us0117 971 1364

Email ussales@thenamethatsticks.com

Get how-to advice, industry news and new innovations — straight to your inbox.