
Apollo A78 has been specifically formulated for use with furniture and seating applications, including the construction of aircraft seating, office seating and flocking applications. It is a single-component sprayable non-flammable polyurethane adhesive.
Find a stockist
This product is supplied by our valued stockists. To find one near you, please click the button below.
Need help?
Call us on 0117 971 1364 or click the button below.
Apollo (A78) has been specifically formulated for use with furniture and seating applications, including the construction of aircraft seating, office seating and flocking applications. It is a single-component sprayable non-flammable polyurethane adhesive.
1. Ensure surfaces to be bonded are clean and free from grease dirt and other contaminants.
2. Apply the adhesive to one surface of the glue line. Apollo recommends using a DeVilbiss JGV-562 gun fitted with an FX fluid tip/needle and a 777 air-cap. An atomising pressure of 70-90 psi and a fluid pressure of 10-15 psi is required.
3. The amount required will vary according to the porosity/ smoothness of the substrate but will normally be in the range of 30-60gms per square meter.
4. Once the adhesive has been applied the substrateshould be assembled and pressed within 15 minutes (at 20°C). A pressure 5-10psi should be sufficient, using a platen or other type of press. Substrate should be pressed for at least 45 minutes (at 20°C), depending on ambient temperature and other atmospheric conditions.
5. When using a heated press place the seat cover in the press and consolidate with heat and pressure until the adhesive has cured.
NB: Condensation of moisture on the surface of the substrate mayoccur under conditions of high humidity, which may result in an unsatisfactory bond.
There are no reviews for this product.
Click the button above to ask a question.
Apollo A78 Astrolok PU Adhesive technical data sheet
Apollo A78 Astrolok PU Adhesive safety data sheet
Use our adhesive coverage calculator to find out how much you need for your project.
Based on your m2 you need:
ltr of Apollo A78 Astrolok PU Adhesive.
Including 10% wastage.
1ltr of Apollo A78 Astrolok PU Adhesive covers 20m2. You require enough product to cover m2 including 10% wastage. m2 / 20m2 per ltr = ltr of product.
Use our adhesive coverage calculator to find out how much you need for your project.
Based on your m2 you need:
ltr of Apollo A78 Astrolok PU Adhesive.
Including 10% wastage.
1ltr of Apollo A78 Astrolok PU Adhesive covers 20m2. You require enough product to cover m2 including 10% wastage. m2 / 20m2 per ltr = ltr of product.
Got an adhesives problem? Let our sticky smarts work for you.
Call us0117 971 1364
Email ussales@thenamethatsticks.com
Get how-to advice, industry news and new innovations — straight to your inbox.