Aro-Bond 1007 Epoxy Primer

PRODUCT OVERVIEW

Aro-Bond® 1007 epoxy primer is ideally suited to metal substrates on applications where interface details are complex, or where substrate adhesion is impaired.

SIZES AVAILABLE

• 1kg kit

Featured Properties

• Improves adhesive
• Compatible with most metallic surfaces
• Minimal preparation required
• Anti-corrosive properties
• Suitable for complex details
• Economical covergae rate

PREPARATION AND APPLICATION

Ensure surfaces are clean and free from debris, fungal growth and any other contaminants before use. Certain non-ferrous matals/ galvanised steels may require special treatment e.g. abraded and/or degreased. However, it is recommended that peel-strength adhesion tests are carried out prior to application, in order to ensure suffiecient adhesion can be achieved and to determine priming requirements.

Substrate temperature should be 5°C or above for application and cure, and a minimum of 3°C above the dew point. Apply Aro-Bond® 1007 using a roller or brush at 0.05-0.10 l/m² approx.

Please contact Ureka if you have any questions regarding specific substrate preparation or application guidelines.

Handling and Storage

Aro-Bond® 1007 should be stored in unopened in a dry condition at a temperature of 5-25°C. Alansons takes every care to ensure that this product reaches you fit for purpose by protecting it with a layer of nitrogen prior to despatch. This ensures a storage life of 12 months, provided that the container is left unopened in a dry condition at a temperature of 5-25°C. the layer of nitrogen will disappear and the product will have a limited life once the container is opened. It is also important to note that carbon dioxide will be given off if water enters the adhesive container, which can cause pressurisation.