Aro-Bond® 680 is a fast drying sprayable contact adhesive based on polychloroprene rubbers and gives a long open time.
Aro-Bond® 680 gives high heat resistance and is used in the lamination and postforming of high pressure laminates.
Aro-Bond® 680 has also proved successful in both the automotive and marine industries for bonding insulation, headlinings and bulkhead materials. Aro-Bond® 680 demonstrates good adhesion to wood, polyurethane foam, elastomers, plastics and metals.
Ensure that the surfaces to be bonded are smooth, clean and free from dust or other deposits.
Surfaces to be bonded should be preconditioned with the adhesive to a temperature within the range 15 - 20°C. Aro-Bond® 680 should be stirred before use.
For best results, Aro-Bond® 680 should be applied using a pump or pressure pot system. Operating the gun approximately 225-300mm from the workpiece, the adhesive should be applied in a fine and even coat to both surfaces to be bonded. After allowing at least 2 minutes for the solvent to flash off, carefully align the substrates and then bring surfaces together using maximum pressure relative to the materials being bonded. Pressure may be applied using a double handed roller, nip roller or a platen press as long as the substrates will not be crushed. Optimum performance is dependent on sufficient pressure being applied. Handling and trimming may be commenced immediately.
Consult Material Safety Data Sheet prior to use.
Aro-Bond® 680 should be stored in the original containers in a cool, dry place, at a temperature range of between 10°C and 25°C. In these conditions it has a storage life of 6 months. Aro-Bond® 680 must not be allowed to freeze.
Click the button above to ask a question.
Used with liquid hardener Prefere 5326X by the separate application method, Aerolite 306 provides a gap-filling, water resistant adhesive which is highly resistant to moulds, fungi etc
Aro-Bond® 548 is an EVA adhesive designed for bonding PVC board that offers additional bonding strength.
The Henko 610 Slotted Blades are used with the Henko 605 Speed Knife