Aro-Bond 695 NF Spray Contact Adhesive

Aro-bond® 695 combines fast drying characteristics, and aggressive tack with rapid bond development and high heat resistance.

In addition to being suitable for bonding flexible foams to each other Aro-bond® 695 is also recommended for bonding foam to metal, chipboard, hardboard, and grp etc, and for the attachment of furnishing fabrics such as hessian, felt, polyester and other upholstery padding materials.  It can also be used for bonding a wide range of insulation materials to metal ducting etc.

SIZES AVAILABLE

• 5ltr tin (Neutral)
• 20ltr tin (Neutral)
• 5ltr tin (Red)
• 20ltr tin (Red)

Featured Properties

• Non-flammable
• Fast drying
• High heat resistance
• Aggressive tack

PREPARATION AND APPLICATION

Materials to be bonded should be dry, clean and free from dust, loose materials, oil and grease. Cut foam should be free from silicone lubricants.

Aro-Bond® 695 may be sprayed through most equipment although it has been designed specifically for low pressure applications. Excellent results may be obtained using a material pressure of 20-30 psi and atomising pressure of 40-60 psi is adequate.

Apply Aro-Bond® 695 to both surfaces to be bonded (except in special cases) and bond immediately or for up to 30 minutes afterwards. Under conditions of high humidity, condensation of moisture on the surface may occur causing a pale ‘bloom’. Under these conditions an unsatisfactory bond is likely.

Handling and Storage

Aro-Bond® 695 should be stored in the original containers in a cool, dry place, at a temperature range of between 5°C and 25°C. In these conditions it has a storage life of 12 months.