Gekko G53 IMO Marine certified contact adhesive

product overview

Gekko G53 is a high performance contact adhesive specifically designed for bonding rubber floor coverings, including marmoleum.  G53 is also IMO ''Wheelmark'' approved so can be used in many applications in the marine industry.

WARNING.  Like other similar products which are commonly found in the market, this product contains dicholoromethane.  Suitable respiratory protection should be used when being used in enclosed areas.  See safety data sheet for more information.

Use with QUIN WEB SPRAY KICK OFF KIT

Featured Properties

• IMO “WHEELMARK” Approved, for a variety of marine Installations.
• Designed for bonding rubber floor coverings.
• Successfully used for bonding Marmoleum.
• Fast drying with a long open time.
• Good temperature resistance of up to 120°C.

HANDLING & STORAGE

• Consult Material Safety Data Sheet prior to use.
• DO NOT store at temperatures over 50°C.
• Avoid exposure to direct sunlight.
• DO NOT store directly on concrete floor.
• For optimum performance, store at 18°C during use, but must always be above 10°C.
• When connected, keep valve open and hose pressurised at all times.
• DO NOT close valve until ready to connect to new cylinder.
• Release pressure in hose before disconnection.
• Always test product to determine suitability for your particular application prior to use in production

DIRECTIONS FOR USE

• This product is designed to be applied to one side of the surfaces to be bonded together, However, It can be used for double sided bonding where required. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 60°F - 80°F (16°C - 27°C).
• Use with adequate ventilation. When possible we recommend shaking the canister well before using. Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
• Prior to use, check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates.

1. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc.

2. Spray about 8” – 18” away at a 45 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 60% to 80% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive.

3. Allow flash off time for the adhesive to tack off. For flash off time and applications please refer to product TDS.

4. Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.

5. If the spray tip clogs, unscrew the spray tip from the gun and clean with warm water. Do not use a pin on the spray tip