PERMABOND ES562 is a single-part epoxy adhesive which flows like solder when heated during curing. The adhesive has excellent adhesion to metal surfaces and composites.
PERMABOND ES562is a single-part epoxy adhesive which flows like solder when heated during curing. The adhesive has excellent adhesion to metal surfaces and composites. The high bond strength of this adhesive allows it to replace mechanical fastening, soldering or brazing. The adhesive’s low viscosity is such that it self-levels.
Storage Temperature - 2 to 7°C (35 to 45°F)
Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces. Some metals such as aluminium, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.
1)The adhesive should be dispensed from the bottlevia the nozzle supplied (this can be cut to give the appropriate sized bead to cover the bond area).
2)Apply the adhesive to one surfaceand avoid entrapping air.
3)Assemble parts applying sufficient pressure to ensure the adhesive spreads to cover the entire bond area.
4)Use a jig / clamp to prevent parts moving during cure.
5)It is advisable not to disturb the joint until the adhesive is fully cured.
6)Cure with heat –see page one for cure schedule.
Click the button above to ask a question.
Permabond ES562 Single Part Epoxy Resin Technical Data Sheet
Permabond ES562 Single Part Epoxy Resin Safety Data Sheet
PERMABOND ES566 is a single-part epoxy adhesive which has excellent adhesion to metal surfaces, composites and difficult to bond plastics (such as Nylon, PBT etc.).
Adtech® 9005 is a fast curing two component structural epoxy adhesive, which cures at room temperature to form a tough, rigid thermoset polymer. Cures in 5 - 10 minutes.
Aro-Bond® 1007 is a two component epoxy based primer for a variety of metallic substrates, with excellent adhesion to steel, galvanised steel and non-ferrous metals.