TensorGrip L22 NON-MECL Fine Web Spray Adhesive

Product overview

TensorGrip L22 is a fine spray adhesive for permanent bonding of materials where immediate bond strength, water resistance and high heat resistance are required. It is suitable for bonding HPL, hard plastics, GRP, foams and fabrics to a variety of substrates including MDF, chipboard, plywood and many other timber sheet materials. The L22 can also be used for bonding sheet metals where surface preparation is very important.

featured properties

• CA Compliant.
• Good Heat Resistance.
• Very High Solids.
• Non-Chlorinated Adhesive.

Developed For

• Aluminum
• Standard Laminate
• Synthetic Leather

• This product is designed to be applied to two surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 60 °F - 80 °F (16 °C - 27 °C).
• We recommend shaking the aerosol can well before using.
• Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 5 - 10 cm (2” – 4”) away at a 90° angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
• Adhere surfaces and press together with adequate pressure. A roller or a mallet is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.