TensorGrip L71 HP Plasticiser Resistant Vinyl & Laminate Spray Adhesive

Product overview

TensorGrip L71 is a revolutionary high performance, plasticiser resistant adhesive, specially formulated for bonding vinyl, rubber and plastics. For use in areas on vinyl and other high plasticised flooring and fabric applications that are prone to failing in the joinery industry.

featured properties

• Bonds Vinyl permanently.
• Very Hi-Temp Resistance - 169°C.
• Bonds To Damp Surfaces.
• High Output For Fast Application.

Developed For

• Aluminum
• Standard Laminate
• Vinyl

• This product is designed to be applied to two surfaces to be bonded together. For best results, the temperature of the adhesive and the surfaces being bonded should be between 60 °F - 80 °F (16 °C - 27 °C).
• Use with adequate ventilation. When possible we recommend shaking the canister well before using.
• Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
• Prior to use, check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. 90°

1. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc.

2. Spray about 10-20 cm (4” – 8”) away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive.

3. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. 4. Allow 4 - 6 minutes for the adhesive to tack off until no adhesive transfers to the knuckle when touched.

5. Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.

6. If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. Do not use a pin on the spray tip orifice.