Free delivery on orders over £500. T&Cs apply

Browse our products

How to operate the multiiiibead Floor Gun for wood floor installations

A simple guide in how to use the innovate multiiiibead floor gun to speed up your wood floor installations

The multiiiibead gun’s innovative dispenser head allows clean and precise application across the width of the floor area to be bonded. Using the correct settings, no adhesive spills on to areas it shouldn’t and no adhesive is left uncovered.

STEP 1 – Install battery pack into tool

Align battery with base of the gun handle and slide the battery pack firmly into the handle until you hear the lock snap into place. To turn the power tool on, squeeze the trigger switch. To turn the tool off, release the trigger switch. Trigger lock safeguards against inadvertent release of material

STEP 2 – Trigger switch & speed dial

Turn the speed dial to an appropriate speed for your application. Then, press the trigger switch to start the flow of material. Release the trigger switch to stop the flow.

STEP 3 – Plunger rod handle

To adjust plunger rod press & hold the plunger rod release trigger. Push or pull plunger rod handle to desired position. Release plunger rod release trigger.

STEP 4 – Removing the dispenser head

Turn the dispenser head anti-clockwise to unscrew from the barrel. Do not pull or cross the thread as this will render the Woodstikk gun inoperable.

STEP 5 – Loading/reloading an adhesive sachet

While squeezing the plunger rod release trigger, pull back the plunger completely. Insert the adhesive sachet into the barrel and cut off the sealing clip. Turn dispenser head clockwise to screw dispenser head back on to the barrel.

STEP 6 – Applying the adhesive

Apply consistent pressure to the trigger to dispense adhesive. Releasing the trigger instantly stops the adhesive flow. Pull the Woodstikk gun at a steady speed.

The dispenser heads are available in widths of 180mm (7”), 300mm (12”) and 400mm (16”). Dispenser nozzles are disposable. Sachets of adhesive are quick and easy to load without any contact with the glue; leaving workspaces and operators clean. As they are used, the sachets are compressed, so that empty sachets form small discs which are easily disposed of. This system ensures best yield and minimal waste.

Featured
Products

SHARE THIS